It would be super handy if you could enable a symmetry building mode. When this mode is toggled on you will be able to select a vertical or horizontal symmetry line. If you selected horizontal for instance, when you try to place a part above or below this line, another copy of the same part will attempt to be placed across the symmetry line. This could also be applied to the selection of an entire group of items, where if the mode is enabled, when you pick up the group of objects, a duplicate is attempted to be placed on the opposite side of the line.
Post
RavenWhisper
It would be super handy if you could enable a symmetry building mode. When this mode is toggled on you will be able to select a vertical or horizontal symmetry line. If you selected horizontal for instance, when you try to place a part above or below this line, another copy of the same part will attempt to be placed across the symmetry line. This could also be applied to the selection of an entire group of items, where if the mode is enabled, when you pick up the group of objects, a duplicate is attempted to be placed on the opposite side of the line.
Link to comment
Share on other sites
3 replies to this post
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now