Darren Posted November 17, 2018 Share Posted November 17, 2018 I have been trying to make a drone that can hover at a certain altitude. However, the altimeter isn't working. It is either going full blast and won't stop or it wont work and just sit there. Is it me or is anybody else experiencing this. 1 Link to comment Share on other sites More sharing options...
Lurkily Posted November 17, 2018 Share Posted November 17, 2018 Are you working with it in the testing area? It behaves rather inconsistently there; 100 altitude sometimes exceeds the height of the testing area, or is below the floor, based on the size of the planet you're on. Give it a shot on a planet; if it works decently, then switch planets until you find one where the testing area works properly. 1 Link to comment Share on other sites More sharing options...
Ookami-sama Posted November 17, 2018 Share Posted November 17, 2018 The testing area is delimited by a square, but has a round gravity field just like the planet it mimics. This is the most mind-shattering design I have found yet in regards to game and physics. As for the altimeter, it worked as intended every time I used it. Try a few different settings is all the advice I can give. 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now